C18

Standard Equipment

• Air inlet system
  • Separate circuit after-cooled (SCAC)
  • Open Crankcase Ventilation (OCV) system
• Turbocharger, jacket water cooled
• Turbocharger inlet, 152 mm (6 in) OD straight connection
• Cooling system
  • SCAC pump, gear driven, for HEX cooled engines only
  • Jacket water pump, gear driven
  • SCAC and JW shunt tanks for maintaining proper pump inlet pressures
• Exhaust system
  • Water-cooled exhaust manifold & turbocharger
  • Round flanged exhaust outlet
• Fuel system
  • Hybrid fuel line design
  • Fuel transfer pump, gear driven
  • Front service simplex fuel system
  • Manual fuel priming pump
• Lube system
  • Center sump oil pan: Deep 500 hour oil change interval
  • Front and top service oil filler locations
  • Front service dipstick
• Oil pump, gear driven
• Mounting system
  • Vibration Isolators
  • Formed C-channel rails
• Control system
  • Common Interface to all Genset Control Panels
  • Programmable Low Idle
  • Electronic Diagnostics and Fault Logging
  • Electronic Fuel/Air Ratio Control
• Programmable ECM Shutdowns for: High Jacket Water Coolant Temp Low Engine Oil Pressure Engine Overspeed

Optional Equipment

• Exhaust system
  • Dry Elbows
  • Water-Cooled Elbows
  • Flexible Fitting
  • Flange
  • Muffler
  • Muffler, Spark Arresting
• Air inlet system
  • Air Inlet Adapter
• Charging system
  • Battery Chargers 10 amp
  • Charging alternator 24V 105 amp
• Control system
  • Caterpillar alarm and protection
  • EMCP 4.2 control panel
  • MGCP III B control panel
• Fuel system
  • Duplex fuel filter – front service
  • Fuel cooler
  • Primary fuel/water separator
• Instrumentation
  • Generator service side - LH, RH
  • Generator terminal box extension
  • Load sharing module (option for type approved module)
• Lube system
  • Duplex oil filter
  • Sump pump
• Protection system
  • Generator protection - IP44
• Starting system
  • Starting motors - electric and/or air
  • Jacket water heaters

Specs